Rega VT Adjuster and Sleeve Nut for Rega Planar 3 etc

A high quality set for adjusting Vertical Tracking Angle on Rega RB250 RB300 and RB600 type Tonearms. Also suits other makes of arm which are based on these models such as Audiomods, Michell and Origin Live, (Not suitable for the Origin Live Onyx).

The VTA Adjuster allows very fine adjustment of height and in combination with the Sleeve Nut allows this to be achieved quickly on thicker plinths and Armboards, (Rega don’t believe in VT Adjustment and make their plinths so thick so that theres minimal thread left below giving very little scope for raising the arm). The Sleeve Nut thread will will fit up into the arm hole therefore allowing more control of height. Arm hole size needs to be a minimum of 24 MM diameter.

Machined from high spec Aluminium Alloy to extremely tight tolerances with a knurled finger grip and finished with a stunning protective Electro plated Anodised finish.

This set is a bonus for suspended type turntables as the VTA Adjuster and Sleeve Nut weigh a lot less than the original Rega nut.

Compatible with all our Rega Armboards and Mounting Plates (non 3 point mounting) without modification but other types of Plates / Armboards may need the hole opening up slightly bigger to accommodate the VTA Adjuster. In my opinion this set is superior to any other on the market in terms of quality and ease of use and fitting.

When using with an RB250 arm please remove the plastic bush at the top of the arm threaded base to expose brass body to allow the arm to drop inside the VTA top collar.

Please note – The Rega nut be it the original or our Sleeve Nut should never be over tightened as you risk damaging the arm and is actually detrimental to sound quality.